Toyota RAV4 Owners Manual: Head restraints
Head restraints are provided for all seats.
Front seats
- Up
Pull the head restraints up.
- Down
Push the head restraint down while
pressing the lock release button.
Rear seats
- Up
Pull the head restraints up.
- Down
Push the head restraint down while
pressing the lock release button.
Folding the head restraints (outboard rear seats only)
- To use
Lift up the head restraint until it locks.
- To fold
Push the head restraint lock
release button to fold the head
restraint.
Removing the head restraints
- Front seats
Pull the head restraint up while pressing
the lock release button.
- Rear seats
Pull the head restraint up while pressing
the lock release button.
Installing the head restraints
- Front seats
Align the head restraint with the installation
holes and push it down while pressing
the lock release button.
- Rear seats
Align the head restraint with the installation
holes and push it down while pressing
the lock release button.
- Adjusting the height of the head restraints
Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.
- Adjusting the rear center seat head restraint
Always raise the head restraint one level from the stowed position when using.
Caution
Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to do so may result in death or serious injury.
- Use the head restraints designed for each respective seat.
- Adjust the head restraints to the correct position at all times.
- After adjusting the head restraints, push down on them and make sure they are locked in position.
- Do not drive with the head restraints removed.
Memory recall function (vehicles with a smart key system)
Each electronic key can be registered to recall your preferred driving
position.
Registering procedure
Record your driving position to button “1” or “2” before performing
the following:
c ...
Other materials:
Disassembly
Remove no. 3 Heater to register duct
Detach the 6 claws and remove the heater to
register duct.
Remove air duct
Detach the 2 claws and remove the air duct.
Remove air outlet control servo motor
Remove the 3 screws.
Detach the evaporator case from the ...
Adjusting the mirrors
Make sure that you can see backward clearly by adjusting the inside
and outside rear view mirrors properly.
Caution
Observe the following precautions.
Failure to do so may result in death or serious injury.
Do not adjust the position of the driver’s seat while driving.
Doing so could ...
Reassembly
Install front oil pump oil seal
Using sst and a hammer, install a new oil seal to
the pump.
Sst 09350-32014 (09351-32140)
Hint:
The seal end should be flat with the outer edge of
the oil pump.
Coat the lip of the oil seal with petroleum jelly.
Install front oil pump bo ...
