Toyota RAV4 manuals

Toyota RAV4 Service Manual: Heated oxygen sensor

Components

Toyota RAV4. Heated oxygen sensor


Removal

  1. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Remove heated oxygen sensor (for bank 1 sensor 2)

Toyota RAV4. Remove heated oxygen sensor (for bank 1 sensor 2)


  1. Disconnect the sensor connector.
  2. Using sst, remove the sensor from the front exhaust pipe.

Sst 09224-00010

Inspection

  1. Inspect heated oxygen sensor (for bank 1 sensor 2)

Toyota RAV4. Inspect heated oxygen sensor (for bank 1 sensor 2)


  1. Measure the resistance of the sensor.

Standard resistance


If the resistance is not as specified, replace the sensor.

Installation

  1. Install heated oxygen sensor (for bank 1 sensor 2)

Toyota RAV4. Install heated oxygen sensor (for bank 1 sensor 2)


  1. Using sst, install the sensor to the front exhaust pipe.

Sst 09224-00010

Torque: 40 n*m (408 kgf*cm, 30 ft.*Lbf) for use with sst

44 N*m (449 kgf*cm, 32 ft.*Lbf) for use without sst

Hint:

  1. Connect the sensor connector.
  1. Connect cable to negative battery terminal

  2. Check for exhaust gas leaks

Air fuel ratio sensor
Components On-vehicle inspection Check air fuel ratio compensation system Connect the intelligent tester to the dlc3. Turn the ignition switch on. Select the following menu item ...

Fuel tank cap
Inspection Inspect fuel tank cap assembly Visually check that the cap and gasket are not deformed or damaged. If the result is not as specified, replace the cap assembly or gaske ...

Other materials:

Brake booster
Installation (2005/11-2006/01) Install check valve grommet Install the grommet to the booster. Install brake vacuum check valve assembly Install the check valve to the grommet. Install brake booster gasket Install a new gasket to the booster. Install brake ...

Fail-safe chart
Fail-safe chart This function minimizes the loss of the ect functions when a malfunction occurs in a sensor or solenoid. Automatic transmission fluid (atf) temperature sensor: when the atf temperature sensor has a malfunction, o/d up-shift is prohibited Counter gear speed sensor n ...

Installation
Install ecm Install the 2 brackets to the ecm with the 4 screws. Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf) Connect the 2 ecm connectors. Notice: When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and ...

В© 2011-2024 Copyright www.trav4.net