Toyota RAV4 Service Manual: Horn relay
On-vehicle inspection
- Remove engine room no. 1 Relay block cover
- Inspect integration relay (unit a: horn relay)
- Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
Hint:
Tape the screwdriver tip before use.
- Measure the resistance of the integration relay.
Standard voltage 
If the result is not as specified, replace the integration relay.
- Install engine room no. 1 Relay block cover
Horn system
Parts location
System diagram
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in ...
Low pitched horn
Components
Removal
Remove radiator support opening cover
(see page et-4)
Remove front fender liner lh (see page et-4)
Remove front fender liner rh (see page et-4)
Remove front bumper ...
Other materials:
Disassembly
Remove radio setting condenser
Remove the bolt and condenser.
Remove oil pressure switch
Using a 24 mm deep socket wrench, remove the sensor.
Remove engine coolant temperature sensor
Using sst, remove the sensor and gasket.
Sst 09817-33190
Remove c ...
Front passenger side rear airbag sensor circuit malfunction
Description
The rear airbag sensor rh consists of parts including the diagnostic circuit
and the lateral deceleration
sensor.
When the center airbag sensor receives signals from the lateral deceleration
sensor, it determines
whether or not the srs should be activated.
Dtc b1635/24 i ...
Sensor (motor) failure
Description
When the sliding roof drive gear (sliding roof ecu) detects the motor's
malfunction, and the sliding roof
operation is stopped, dtc b2341 is output. When the sliding roof drive gear
(sliding roof ecu) detects the
gear's malfunction, and the sliding roof operation is stopped, d ...
