Hint:
Perform troubleshooting in accordance with the following flowchart.
*: Use the intelligent tester.
Standard voltage: 11 to 14 v
If the voltage is below 11 v, recharge or replace the battery before proceeding.
Result
Hint:
Result
Result
End
Second brake piston
Components
Disassembly
Remove 2nd brake piston return spring sub-assembly
Place sst on the return spring and compress.
Using a screwdriver, pry out the snap ring.
Remove the piston return spring.
Inspect 2nd brake piston return spring sub-assembly (see page ax-223)
...
Short in can bus lines
Description
There may be a short circuit between the can bus lines when the resistance
between terminals 6 (canh)
and 14 (canl) of the dlc3 is below 54
.
Wiring diagram
Inspection procedure
Notice:
Turn the ignition switch off before measuring the resistances of the
main ...
Srs warning light remains on
Description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light comes on for approximately 6
seconds after the ignition
switch is turned from off to on, and then goes off automatically.
If there is a malfunction in the srs, the srs warni ...