Toyota RAV4 (XA40) 2013-2018 Service Manual: How to proceed with troubleshooting
Hint:
- Use these procedures to troubleshoot the tire pressure warning system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Inspect battery voltage
Standard voltage: 11 to 14 v
If the voltage is below 11 v, recharge or replace the battery before proceeding.
- Check indicator light
- Check the indicator light (see page tw-17).
- Check dtc*
- Check for dtc (see page tw-20).
- Clear the dtc (see page tw-20).
- Recheck for dtc (see page tw-20).
Result 
- Dtc chart
- Check for tire pressure warning system dtc output (see page tw-22).
- Problem symptom confirmation
- Problem symptoms table
Result
- Overall analysis and troubleshooting*
- Terminals of ecu (see page tw-16).
- Data list/active test (see page tw-21).
- Repair or replace
- Confirmation test
End
System description
Description of system
A tire pressure warning antenna and receiver is
equipped with a tire pressure sensor and a
transmitter and is installed in each tire wheel. The
sensor measures the ...
Registration
In case of tire pressure warning ecu
replacement
Read id stored in the old ecu using the intelligent
tester.
In case of tire pressure warning valve and
transmitter and/or tire pre ...
Other materials:
Steering angle sensor
Components
Removal
Precaution
Caution:
Be sure to read the "precaution" thoroughly
before servicing (see page rs-1).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
Seat position airbag sensor circuit malfunction
Description
The seat position sensor circuit consists of the center airbag sensor and the
seat position sensor.
Dtc b1653/35 is recorded when a malfunction is detected in the seat position
sensor circuit.
Wiring diagram
Inspection procedure
Check for dtc
Turn the ...
Installation
Install ignition switch assembly
Install the ignition switch with the 2 screws.
Install the ignition key cylinder light connector.
Install the ignition switch connector.
Install steering column cover lower
Attach the 4 claws to install the steering column
l ...
