Toyota RAV4 Service Manual: How to proceed with troubleshooting
Hint:
- Use the procedure to troubleshoot the power door lock control system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Inspect battery voltage
Standard voltage: 11 to 14 v
If the voltage is below 11 v, recharge or replace the battery before proceeding.
- Problem symptoms table
- Overall analysis and troubleshooting*
- Operation check (see page dl-6 ).
- Terminals of ecu (see page dl-8).
- Data list / active test (see page dl-12).
- Adjust, repair or replace
- Confirmation test
End
System description
Power door lock system description
The power door lock system locks / unlocks all
doors with a one-touch operation.
The door control switch of the power window
regulator master swit ...
Operation check
Check electrical door lock operation
Check the basic function.
Check that all doors lock when the door control
switch (for manual operation) is turned to lock
and all doors unlock w ...
Other materials:
Rear seat inner belt assembly
Components
Removal
Remove rear seat leg cover
Remove rear no. 2 Seat leg side cover
Remove rear no. 3 Seat leg side cover (w/
rear no. 2 Seat) (see page se-81)
Remove rear no. 3 Seat leg side cover (w/o
rear no. 2 Seat) (see page se-81)
Remove rear no. 4 Seat leg side co ...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
troubleshooting is one way to save time.
Connect the intelligent tester (with can vim) to the
dlc3 ...
Freeze frame data
Freeze frame data
Hint:
Whenever a dtc is detected or the abs operates,
the skid control ecu stores the current vehicle
(sensor) state as freeze frame data.
The skid control ecu stores the number of times
(maximum: 31) the ignition switch has been turned
from off to on since the ...
