Toyota RAV4 (XA40) 2013-2018 Service Manual: How to proceed with troubleshooting
Hint:
- Use these procedures to troubleshoot the key reminder warning system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Inspect battery voltage
Standard voltage: 11 to 14 v
Hint:
If the voltage is below 11 v, recharge or replace the battery before proceeding.
- Inspect communication function of can communication system*
- Use the intelligent tester to check if the can communication system is functioning normally.
Result: 
- Problem symptoms table
- Overall analysis and troubleshooting*
- Operation check (see page dl-79)
- Terminals of ecu (see page dl-80)
- Data list / active test (see page dl-83)
- Repair or replace
- Confirmation test
End
System description
Key reminder warning system description
When the driver side door is opened with the key in
the ignition key cylinder and ignition switch in the
acc or off position, this system causes th ...
Operation check
Check key reminder warning system
Check that the key reminder warning buzzer
sounds.
With the driver side door closed, insert the key
into the ignition key cylinder and then turn th ...
Other materials:
Manual air conditioning system
Air conditioning controls
Fan speed control switch
Temperature control switch
On/off switch
Windshield defogger switch
Rear window and outside rear view mirror defoggers* switch
Airflow mode control switch
Outside/recirculated air mode switch
"A/C" switch
"MAX A/C" switch
*: If equipped
...
Installation
Hint:
When installing the spoiler, heat the vehicle body and
spoiler using a heat light.
Standard heating temperature
Notice:
Do not heat the body and spoiler excessively.
Install center stop light
Install the center stop light with the 2 screws.
Install rear spoiler
...
Installation
Install water pump assembly
Remove any old seal packing material from the
contact surface.
Apply a continuous line of seal packing as shown in
the illustration.
Seal packing:
toyota genuine seal parking black, three
bond 1207b or equivalent
Standard seal diameter:
2.2 To 2. ...
