Toyota RAV4 Service Manual: How to proceed with troubleshooting (2005/11-2006/01)
Hint:
- Use these procedures to troubleshoot the air conditioning
system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Customer problem analysis and symptom check
- Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
- Check can communication system*
- Use the intelligent tester to check if the can
communication system is functioning.
Result
- Check dtc or check sensor check code through panel diagnosis*
- Check dtcs or sensor check codes.
- Write down the dtcs or sensor check codes.
- Clear the dtcs or sensor check codes.
- Check whether the dtcs or sensor check codes recur.
- Reproduce the problem symptoms in accordance
with the dtcs or sensor check codes that were
written down, and check whether the dtcs or
sensor check codes recur.
Hint:
Refer to the dtc chart when any dtcs or sensor
check codes are output.
Result
- Refer to problem symptoms table
Result
- Overall analysis and troubleshooting*
- Data list / active test (see page ac-34)
- Panel diagnosis (indicator check) (see page ac-31)
- Panel diagnosis (actuator check) (see page ac-31)
- Panel diagnosis (sensor check) (see page ac-31)
- Terminals of ecu (see page ac-24)
- Adjust, repair or replace
- Confirmation test
End
General
The air conditioning system has the following
features:
In accordance with the temperature set using the
temperature control switch, the air conditioning
amplifier determi ...
Hint:
Use these procedures to troubleshoot the air conditioning
system.
*: Use the intelligent tester.
Vehicle brought to workshop
Customer problem analysis and symptom check
...
Other materials:
Diagnosis system
Description
Engine immobiliser system data and diagnostic
trouble codes (dtcs) can be read through the
vehicle's data link connector 3 (dlc3). In some
cases, a malfunction may be occurring in the engine
immobiliser system even though the security
indicator light is not illuminated ...
Ecm communication circuit malfunction
Description
The circuit is used to send trc and vsc control information from the skid
control ecu to the ecm, and
engine control information from the ecm to the skid control ecu.
Inspection procedure
Hint:
Check that the part numbers of the installed ecm and skid control ecu are
cor ...
Horn relay
On-vehicle inspection
Remove engine room no. 1 Relay block cover
Inspect integration relay (unit a: horn relay)
Using a screwdriver, detach the 2 claws and
disconnect the integration relay from the engine
room junction block.
Hint:
Tape the screwdriver tip before use.
Mea ...