Toyota RAV4 Service Manual: How to proceed with troubleshooting (2005/11-2006/01)
Hint:
- Use these procedures to troubleshoot the air conditioning system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Customer problem analysis and symptom check
- Inspect battery voltage
Standard voltage: 11 to 14 v
If the voltage is below 11 v, recharge or replace the battery before proceeding.
- Check can communication system*
- Use the intelligent tester to check if the can communication system is functioning.
Result 
- Check dtc*
- Check for dtcs and write down any dtcs that are output.
- Clear the dtcs.
- Recheck for dtcs. Based on the dtcs output above, try to cause output of the air conditioning system dtc by simulating the operation indicated by the dtc.
Result 
- Refer to problem symptoms table
Result 
- Overall analysis and troubleshooting*
- Data list / active test (see page ac-127)
- Terminals of ecu (see page ac-122)
- Adjust, repair or replace
- Confirmation test
End
System description
General
The air conditioning system has the following
features:
The air conditioning amplifier controls the
operation of parts, such as the a/c compressor,
automatically in accord ...
How to proceed with troubleshooting (2006/01- )
Hint:
Use these procedures to troubleshoot the air conditioning
system
*: Use the intelligent tester.
Vehicle brought to workshop
Customer problem analysis and symptom check
...
Other materials:
Steering angle sensor zero point malfunction
Description
The skid control ecu learns the steering sensor zero point every time the
ignition switch is turned on and
the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds.
The ecu also stores the
previous zero point.
If front wheel alignment or the steering wh ...
Short in front passenger side pretensioner squib circuit
Description
The front passenger side front pretensioner squib circuit consists of the
center airbag sensor and the front
seat outer belt rh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in th ...
Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2 Clamp lh
One touch type:
Using a screwdriver, remove the inboard joint
boot clamp, as shown in the illustration.
Claw engagement type:
Using needle-nose pliers, remove the inboard
joint boot clamp, as shown in the illustra ...
