Toyota RAV4 Service Manual: How to proceed with troubleshooting (2006/01- )
Hint:
- Use these procedures to troubleshoot the air conditioning
system.
- *: Use the intelligent tester.
- Vehicle brought to workshop
- Customer problem analysis and symptom check
- Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
- Check can communication system*
- Use the intelligent tester to check if the can
communication system is functioning.
Result
- Check dtc or check sensor check code through panel diagnosis*
- Check dtcs or sensor check codes.
- Write down the dtcs or sensor check codes.
- Clear the dtcs or sensor check codes.
- Check whether the dtcs or sensor check codes recur.
- Reproduce the problem symptoms in accordance
with the dtcs or sensor check codes that were
written down, and check whether the dtcs or
sensor check codes recur.
Hint:
Refer to the dtc chart when any dtcs or sensor
check codes are output.
Result
- Refer to problem symptoms table
Result
- Overall analysis and troubleshooting*
- Data list / active test (see page ac-37)
- Panel diagnosis (indicator check) (see page ac-31)
- Panel diagnosis (sensor check) (see page ac-31)
- Panel diagnosis (actuator check) (see page ac-31)
- Terminals of ecu (see page ac-27)
- Adjust, repair or replace
- Confirmation test
End
Hint:
Use these procedures to troubleshoot the air conditioning
system.
*: Use the intelligent tester.
Vehicle brought to workshop
Customer problem analysis and symptom check
...
Hint:
The following items can be customized.
Notice:
When the customer requests a change in a function,
first make sure that the function can be customized.
Be sure to make a note of the cur ...
Other materials:
Back-up power source circuit
Description
This is the back-up power source circuit for the air conditioning amplifier.
Power is supplied even when the
ignition switch is turned off and is used for functions such as the diagnostic
trouble code memory.
wiring diagram
Inspection procedure
Inspect fuse (ecu-b2)
...
Solenoid circuit
Description
This solenoid is turned on in accordance with signals from the skid control
ecu and controls the pressure
on the wheel cylinders to control the braking force.
The solenoid and solenoid relay are built into the abs and traction actuator.
Hint:
Dtcs c0226/21, c0236/22, c02 ...
Inside rear view mirror
The rear view mirror’s position can be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view mirror
The height of the rear view mirror can be adjusted to suit your driving
posture.
Adjust the height of the rear view
mirror by moving it up and down.
...