Toyota RAV4 Service Manual: Hydraulic test
- Measure line pressure
Notice:
- Perform the test at the normal operating atf temperature: 50 to 80°c (122 to 176°f).
- The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels or wheel chocks while the other is performing the test.
- Be careful to prevent sst's hose from interfering with the exhaust pipe.
- This test must be performed after checking and adjusting the engine.
- Perform the test with the a/c off.
- When conducting the stall test, do not continue for more than 10 seconds.
- Warm up the atf.
- Remove the test plug on the transaxle case center right side and connect sst.
Sst 09992-00095 (09992-00231, 09992-00271)
- Fully apply the parking brake and chock the 4 wheels.
- Start the engine and check the idling speed.
- Keep your left foot firmly on the brake pedal and move the shift lever to d.
- Measure the line pressure when the engine is idling.
- Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
- Perform the measure line pressure test again with the shift lever on r.
Specified line pressure:
Evaluation:
Mechanical system tests
Stall speed test
Hint:
This test is to check the overall performance of the
engine and transaxle.
Notice:
Do not perform the stall speed test longer than 5
seconds.
To ensure safety, ...
Manual shifting test
Manual shifting test
Hint:
Through this test, it can be determined whether the
trouble occurs in the electrical circuit or if it is a
mechanical problem in the transaxle.
If any abnorm ...
Other materials:
Seat belt pretensioners (front seats)
The pretensioners help the seat
belts to quickly restrain the occupants
by retracting the seat belts
when the vehicle is subjected to
certain types of severe frontal or
side collision or a vehicle rollover.
The pretensioners do not activate
in the event of a minor frontal
impact, a minor ...
Emission control system
Parts location
System diagram
On-vehicle inspection
Check fuel cut rpm
Increase the engine speed to at least 3,500 rpm.
Use a sound scope to check for injector operating
noise.
Check that the operating sounds stop momentarily
and then resume when the t ...
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and ...
