If the engine will not start even though correct starting procedures are being followed („_p. 197, 200), Consider each of the following points:
The engine will not start even though the starter motor operates normally.
One of the following may be the cause of the problem:
Refuel the vehicle.
Try to restart the engine again following correct starting procedures.
The starter motor turns over slowly, the interior lights and headlights are dim, or the horn does not sound or sounds at a low volume.
One of the following may be the cause of the problem:
The starter motor does not turn over (vehicles with a smart key system).
The engine starting system may be malfunctioning due to an electrical problem such as an open circuit or a blown fuse. However, an interim measure is available to start the engine.
The starter motor does not turn over, the interior lights and headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
Contact your toyota dealer if the problem cannot be repaired, or if repair procedures are unknown.
Emergency start function (vehicles with a smart key system)
When the engine does not start, the following steps can be used as an interim measure to start the engine if the engine switch is functioning normally:
Even if the engine can be started using the above steps, the system may be malfunctioning. Have the vehicle inspected by your toyota dealer.
If you have a flat tire
If the shift lever cannot
be shifted from pCheck mode procedure
Hint:
Intelligent tester only:
compared to normal mode, check mode is more sensitive to
malfunctions. Therefore, check mode can detect the
malfunctions that cannot be detected by normal mode.
Notice:
All the stored dtcs and freeze frame data are erased if:
The ecm is changed from normal mo ...
Auto lsd indicator light does not come on
Description
Refer to the description of "auto lsd indicator light remains on" (see page
bc-164).
Wiring diagram
Refer to the auto lsd indicator light circuit (see page bc-165).
Inspection procedure
Check can communication system
Check if the can communication system dtc is ...
Precaution
Before disassembling the differential assembly,
thoroughly clean it by removing any sand, mud or
foreign matter. This will help prevent contamination
during disassembly and reassembly.
When removing the rear differential carrier cover or
any other light alloy part, do not pry it off wit ...