Toyota RAV4 (XA40) 2013-2018 Owners Manual: If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure:
- Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to slow the vehicle.
- Shift the shift lever to n.
If the shift lever is shifted to n
- After slowing down, stop the vehicle in a safe place by the road.
- Stop the engine.
If the shift lever cannot be shifted to n
- Keep depressing the brake pedal with both feet to reduce vehicle speed as much as possible.
- Vehicles without a smart key system: stop the engine by turning the engine switch to the “acc” position.
- Vehicles with a smart key system: to stop the engine, press and hold the engine switch for 2 consecutive seconds or more, or press it briefly 3 times or more in succession.
- Stop the vehicle in a safe place by the road.
Caution
If the engine has to be turned off while driving
- Power assist for the brakes and steering wheel will be lost,
making the
brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
- Vehicles without a smart key system: never attempt to remove the key, as doing so will lock the steering wheel.
Emergency flashers
The emergency flashers are used to warn other drivers when the
vehicle has to be stopped in the road to a breakdown, etc.
Press the switch.
All the turn signals will flash.
To turn them off, p ...
Other materials:
Adjusting the settings
To adjust the fan speed, turn the fan speed control dial clockwise
(increase) or counterclockwise (decrease).
Turning the dial to “0” turns off the fan.
To adjust the temperature setting, turn the temperature control dial
clockwise (warm) or counterclockwise (cool).
If is ...
Cooling fan system
Parts location
System diagram
On-vehicle inspection
Hint:
It is normal for the cooling fan to sometimes rotate when the
ignition switch is turned from acc to on.
Check cooling fan operation at low temperatures (below 94°c (201°f))
Turn the ignition switch on with the a/c ...
Intermediate shaft speed sensor "A"
Description
This sensor detects the rotation speed of the counter gear. By comparing the
counter gear speed signal
(nc) with the direct clutch speed sensor signal (nt), the ecm detects the shift
timing of the gears and
approximately controls the engine torque and hydraulic pressure accord ...
