Toyota RAV4 (XA40) 2013-2018 Service Manual: Ig1 relay
On-vehicle inspection
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove ig1 relay
- Remove the ig1 relay from the instrument panel junction block.
- Inspect relay
- Measure resistance of the ig1 relay.
Standard resistance 
If the result is not as specified, replace the relay.
- Install ig1 relay
- Connect cable to negative battery terminal
Integration relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airb ...
Ig2 relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airb ...
Other materials:
Door control transmitter module
Components
Removal
Remove transmitter housing cover
Notice:
Take extra care when handling these precision
electronic components.
Twist the screwdriver in the direction of the arrow
mark in the illustration, and open the transmitter
housing cover.
Notice:
Do not forcibly pry ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove no. 1 Engine under cover
Remove front fender apron rh
Remove radia ...
Rear differential side gear shaft oil seal
Components
Removal
Drain differential oil (see page df-10)
Remove tailpipe assembly
Remove the tailpipe (see page ex-2).
Remove center exhaust assembly
Remove propeller with center bearing
shaft assembly (see page pr-3)
Remove rear differential carrier subassembl ...
