On-vehicle inspection
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Standard resistance
If the result is not as specified, replace the relay.
Motor terminal voltage malfunction
Description
The power steering ecu supplies the current to the power steering motor
through the motor circuit.
Wiring diagram
Inspection procedure
Read value of intelligent tester (motor voltage)
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignitio ...
Axle system
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
the table. Check each symptom by checking the suspected
areas in the order th ...
Throttle / pedal position sensor / switch "A" circuit range / performance
problem
Hint:
This dtc relates to the throttle position (tp) sensor.
Description
Refer to dtc p0120 (see page es-114).
Monitor description
The ecm uses the tp sensor to monitor the throttle valve opening angle.
This sensor transmits two signals: vta1 and vta2. Vta1 is used to detect the
th ...