Toyota RAV4 Service Manual: Ig power supply voltage malfunction
Description
The power steering ecu distinguishes the ignition switch status as on or off
through the ig power
source circuit.
Wiring diagram
Inspection procedure
- Read value of intelligent tester (ig power supply)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Select the item "ig supply" in the data list and read the value displayed on the intelligent tester.
- Inspect fuse (ecu-ig1)
- Remove the ecu-ig1 fuse from the instrument panel junction block.
- Measure the resistance of the fuse.
Ok:
below 1 
- Check harness and connector (battery - power steering ecu)
- Disconnect the e18 and a1 power steering ecu connectors.
- Measure the voltage of the wire harness side connectors.
Standard voltage
Replace power steering ecu
Ecu malfunction
Description
Inspection procedure
If the power steering ecu detects these dtcs, it will shut off the motor
relay circuit (built into the power
steering ecu) and stop power assist. However, pow ...
Pig power supply voltage malfunction
Description
When a problem occurs in the system, the power source relay circuit is shut
off to stop the power assist.
Wiring diagram
Inspection procedure
Read value of intelligent ...
Other materials:
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the rh side.
Remove front seat headrest assembly
Remove front seat assembly
Operate the power seat switch knob and move the
seat to the foremost position.
Using a screwdriver, d ...
General maintenance
Listed below are the general maintenance items that should be
performed at the intervals specified in the “owner’s warranty
information booklet” or “owner’s manual supplement/scheduled
maintenance guide”. It is recommended that any problem
you notice should be brought to the attentio ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove fan and generator v belt
Remove the belt (see page em-6).
...
