Toyota RAV4 Service Manual: Inspection
- Inspect front seat outer belt assembly
Notice:
Do not disassemble the retractor.
- Before installing the outer belt, check the elr.
- When the inclination of the retractor is 15Ð or
less, check that the belt can be pulled from the
retractor. When the inclination of the retractor is
over 45Ь check that the belt locks.
If the result is not as specified, replace the outer belt assembly.
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 ...
Installation
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
A bolt without a torque specification is shown in the
standard bolt chart (see pag ...
Other materials:
Air inlet control servo motor
Components
Removal
Remove blower assembly
Remove the blower (see page ac-203).
Remove air inlet control servo motor (see
page ac-210)
Inspection
Inspect air inlet control servo motor (for automatic air conditioning
system)
Inspect the servo motor operation. ...
Seat heater system
Parts location
System diagram
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column
of the table. Check each symptom by check ...
Turning the high beam on/off manually
Switching to low beam
Pull the lever to original position.
Switching to high beam
Turn the light switch to
position.
The automatic high beam indicator
will turn off and the high
beam indicator will turn on.
The automatic high beam can be operated when
Vehicles without a smart ke ...
