Toyota RAV4 manuals

Toyota RAV4 Service Manual: Inspection

  1. Inspect camshaft timing oil control valve assembly

  1. Measure the resistance of the oil control valve.

Standard resistance


If the result is not as specified, replace the oil control valve assembly.

Toyota RAV4. Inspection


  1. Check the operation.
  1. Apply battery voltage across the terminals and check that the spool valve operates.

Toyota RAV4. Inspection


Notice:

Check that the spool valve is not stuck.

Hint:

The spool valve may not return if foreign objects are caught in it. This may cause subtle pressure leaks to the advance side, and a dtc may be set.

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Installation
Install camshaft timing oil control valve assembly Apply a light coat of engine oil to the o-ring of the oil control valve. Install the oil control valve with the bolt. Torque: 9 ...

Other materials:

Installation (2005/11-2006/01)
Install front drive shaft assembly lh Coat the spline of the inboard joint shaft with gear oil. Using a brass bar and hammer, align the shaft splines in the drive shaft. Notice: Set the snap ring with the opening side facing downwards. Be careful not to damage the oil s ...

Lubrication system
On-vehicle inspection Check engine oil level Warm up the engine, stop the engine and wait for 5 minutes. Check that the engine oil level is between the l and f marks of the oil dipstick. If low, check for leakage and add oil up to the f mark. Notice: Do not add engine oil a ...

Removal
Notice: Do not heat the vehicle body, emblem and name plate excessively. Hint: When removing the emblem and name plate, heat the vehicle body, emblem and name plate using a heat light. Standard heating temperature Remove no. 1 Back door emblem assembly Put protective tape aroun ...

В© 2011-2022 Copyright www.trav4.net