Toyota RAV4 manuals

Toyota RAV4 Service Manual: Inspection

  1. Inspect engine coolant temperature sensor

  1. Measure the resistance of the sensor.

Toyota RAV4. Inspect engine coolant temperature sensor


Standard resistance


Notice:

If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.

If the result is not as specified, replace the sensor.

Removal
Drain engine coolant (see page co-6) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal ...

Installation
Install engine coolant temperature sensor Install a new gasket onto the sensor. Using sst, install the sensor. Sst 09817-33190 torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf) Connect th ...

Other materials:

Removal (2006/01- )
Remove front wheel Drain automatic transaxle fluid Drain the automatic transaxle fluid for u140f (see page ax-147). Drain the automatic transaxle fluid for u241e (see page ax-146). Drain the automatic transaxle fluid for u151f (see page ax-173). Remove front axle hub nut ( ...

Installation
Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. A bolt without a torque specification is shown in the standard bolt chart (see page ss-2). Install front shoulder belt anchor adjuster assembly Align the adjuster pos ...

Screen for general settings
Press the “setup” button. Select “general” on the “setup” screen. “English”, “français” or “español” can be selected. On/off can be selected to sound beeps. Select to change the screen color. Select to change the keyboard layout. ...

© 2011-2024 Copyright www.trav4.net