Toyota RAV4 Service Manual: Inspection
- Inspect knock sensor
- Measure the resistance of the sensor.
Standard resistance 
If the result is not as specified, replace the knock sensor.
Removal
Discharge fuel system pressure (see page
fu-9)
Drain coolant (see page co-6)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
c ...
Installation
Install knock sensor
Install the sensor with the nut.
Torque: 20 n*m (205 kgf*cm, 15 ft.*Lbf)
Notice:
Make sure that the knock sensor is in the
correct position.
Connect the sen ...
Other materials:
Head restraints
Head restraints are provided for all seats.
Front seats
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock release button.
Rear seats
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock rel ...
Front speed sensor
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
Throttle / pedal position sensor / switch "A" circuit range / performance
problem
Hint:
This dtc relates to the throttle position (tp) sensor.
Description
Refer to dtc p0120 (see page es-114).
Monitor description
The ecm uses the tp sensor to monitor the throttle valve opening angle.
This sensor transmits two signals: vta1 and vta2. Vta1 is used to detect the
th ...
