Notice:
These tests must be performed within 3 to 5 seconds to avoid burning out the coil.
If the clutch pinion gear does not move, replace the magnetic switch.
If the clutch pinion gear returns inward, replace the magnetic switch.
If the clutch pinion gear does not return, replace the magnetic switch.
Then measure the current.
Standard current: 90 a or less at 11.5 V
If result is not as specified, replace the starter assembly.
If necessary, replace the magnetic switch assembly.
Standard resistance: below 1
If the result is not as specified, replace the magnetic switch assembly.
Standard resistance: below 2
If the result is not as specified, replace the magnetic switch assembly.
Standard resistance: below 1
If the result is not as specified, replace the armature assembly.
Standard resistance: 10 k or higher
If the result is not as specified, replace the armature assembly
If the surface is dirty or burnt, correct it with sandpaper (no. 400) Or a lathe
Standard length: 3.1 To 3.8 Mm (0.122 To 0.150 In.)
If the length is greater than the maximum, replace the starter armature assembly.
Standard length: 4.0 To 9.0 Mm (0.158 To 0.359 In.)
If the length is less than the minimum, replace the end frame assembly.
Standard resistance: 10 k or higher
If the result is not as specified, repair or replace the end frame assembly.
If necessary, replace the starter drive housing assembly.
Tire pressure warning valve and transmitter
Components
Removal
Remove front tire
Remove rear tire
Remove tire pressure warning valve subassembly
Remove the valve core and cap, and release air
from the tire.
After ensuring that air is sufficiently released,
remove the nut and washer that are used to fix the
tire pres ...
Installation
Install rear no. 1 Seat assembly lh (w/o rear no. 2 Seat)
Fully tilt the seatback forward.
Place the seat in the cabin.
Notice:
Be careful not to damage the vehicle body.
Connection procedures of seat to lock cable when
reusing seat:
Using a screwdriver, detach the cla ...
Diagnosis system
Description
Sliding roof system data and diagnostic trouble
codes (dtcs) can be read through the vehicle's
data link connector 3 (dlc3). When the system
seems to be malfunctioning, use the intelligent
tester to check for malfunctions and perform repairs.
Check dlc3
The vehi ...