Toyota RAV4 (XA40) 2013-2018 Service Manual: Inspection
- Inspect ignition switch assembly
- Measure the resistance of the switch.
Standard resistance 
If the result is not as specified, replace the switch assembly.
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt preten ...
Installation
Install ignition switch assembly
Install the ignition switch with the 2 screws.
Install the ignition key cylinder light connector.
Install the ignition switch connector.
...
Other materials:
Receiving a call
When a call is received, the following screen is displayed
together with a sound.
To answer the phone
Press the switch on the
steering
wheel or select .
To refuse a call
Press the switch on the
steering wheel or select .
To adjust the incoming call volume
...
Disassembly
Remove radio setting condenser
Remove the bolt and condenser.
Remove oil pressure switch
Using a 24 mm deep socket wrench, remove the sensor.
Remove engine coolant temperature sensor
Using sst, remove the sensor and gasket.
Sst 09817-33190
Remove c ...
Parts location
System diagram
Hint:
The abs and traction actuator (skid control ecu)
detects and stores steering sensor and yaw rate
sensor dtcs and performs dtc communication by
receiving information from the steering sensor and
yaw rate sensor.
The ecm uses the can communication sy ...
