Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Inspection

  1. Inspect water pump assembly

Toyota RAV4. Inspect water pump assembly


  1. Visually check the drain hole for coolant leakage.

    If leakage is found, replace the water pump assembly.

  2. Turn the pulley, and then check that the water pump bearing moves smoothly without making a "click" noise.

    If it does not move smoothly, replace the water pump assembly.

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Installation
Install water pump assembly Remove any old seal packing material from the contact surface. Apply a continuous line of seal packing as shown in the illustration. Seal packing: to ...

Other materials:

Stuck in deceleration sensor
Description The skid control ecu receives signals from the yaw rate and deceleration sensor via the can communication system. The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (gl1: g sensor 1, gl2: g sensor 2). If there is t ...

Steering gear
Components Removal Position front wheels facing straight ahead Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. ...

Tc and cg terminal circuit
Description Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light. Wiring diagram Inspection procedure Check dlc3 (tc voltage) Turn the ignition switch on. Measure the voltage of the dlc3. Standar ...

В© 2011-2026 Copyright www.trav4.net