Toyota RAV4 Service Manual: Installation
Hint:
- Use the same procedures for the lh side and rh side.
- The procedures listed below are for the lh side.
- A bolt without a torque specification is shown in the standard bolt chart (see page ss-2).
- Install front shoulder belt anchor adjuster assembly
- Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.
Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)
- Install front shoulder belt anchor plate sub-assembly lh
- Install the plate as shown in the illustration.
Hint:
Make sure the plate is firmly set into the garnish's claws.
- Install front seat outer belt assembly lh
Notice:
Do not disassemble the retractor.
- Align the 2 claws with the seat belt positioning
holes, and install the retractor of the outer belt with
the bolt as shown in the illustration.
Torque: 8.5 N*m (87 kgf*cm, 75 in.*Lbf)
- Connect the pretensioner connector as shown in the illustration.
- Connect the outer belt with the shoulder anchor's
bolt.
Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)
- Install center pillar garnish lh
- Pass the outer belt anchor through the center pillar garnish.
- Attach the clip.
- Install the garnish with the 2 screws.
- Install center pillar garnish lower lh
- Attach the 2 claws and 2 clips to install the garnish.
- Connect the floor anchor with the bolt.
Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)
- Attach the lap belt outer anchor cover
- Install rear door opening trim weatherstrip lh
- Install rear door scuff plate lh (see page ir-57)
- Install front door scuff plate lh (see page ir-59)
- Install front door opening trim weatherstrip lh
- Connect cable to negative battery terminal
Inspection
Inspect front seat outer belt assembly
Notice:
Do not disassemble the retractor.
Before installing the outer belt, check the elr.
When the inclination of the retractor is 15Ð or
...
Disposal
Hint:
When scrapping vehicles equipped with a seat belt
pretensioner or disposing of a front seat outer belt (with seat
belt pretensioner), always first activate the seat belt
pretensioner in acco ...
Other materials:
Check mode procedure
Hint:
Intelligent tester only:
compared to normal mode, check mode is more sensitive to
malfunctions. Therefore, check mode can detect the
malfunctions that cannot be detected by normal mode.
Notice:
All the stored dtcs and freeze frame data are erased if:
The ecm is changed from normal mo ...
Reassembly
Caution:
Wear protective gloves. Sharp areas on the seat frame
(with adjuster) may injure your hands.
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install occupant classification ecu (for
driver side) (see page rs-394)
...
Low battery positive voltage
Description
When there is an abnormality in the power supply circuit of the brake
actuator (skid control ecu), the skid
control ecu sets a dtc and the operation is prohibited by the fail-safe
function. This dtc is set when the
voltage supplied to terminal ig1 is outside the dtc detection ...
