Toyota RAV4 Service Manual: Installation
Caution:
Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
- Install front passenger airbag assembly
- Attach the rear side hook of the front passenger airbag to the rear side airbag door.
- Bend the front side hook so that it attaches to the front side airbag door.
- Install the instrument panel upper (see page ip-9).
- Install the 2 bolts to the reinforcement.
Torque: 20 n*m (203 kgf*cm, 14 ft.*Lbf)
- Connect the connector to the airbag.
Notice:
When handling the airbag connector, do not damage the airbag wire harness.
- Attach the wire harness clamp to the bracket.
- Install glove compartment door assembly (see page ip-9)
- Connect cable to negative battery terminal
- Check srs warning light
- Check the srs warning light (see page rs-34).
Removal
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Disconnect cable from negative battery
terminal
Caution:
Wait at le ...
Disposal
Hint:
When scrapping a vehicle equipped with an srs or disposing
of the front passenger side knee airbag, be sure to deploy the
airbag first in accordance with the procedure described
below. If an ...
Other materials:
Precaution
If any of following conditions are met,
keep engine idling with a/c on (engine
speed at less than 2000 rpm) for at least 1
minute:
Refrigerant gas has been refilled or a/c parts have
been replaced.
A long time has elapsed since the engine was
stopped.
Notice:
If the engine s ...
Fuel injector
Components
Removal
Discharge fuel system pressure
Caution:
Discharge fuel system pressure
procedures must be performed before
disconnecting any part of the fuel system.
After performing the discharge fuel system
pressure procedures, pressure will remain in
the fuel line ...
Light control switch circuit
Description
This circuit detects the state of the headlight dimmer switch.
Wiring diagram
Inspection procedure
Read value of intelligent tester (main body ecu)
Connect the intelligent tester to the dlc3.
Turn the ignition switch on and press the intelligent
tester main switch on ...
