Toyota RAV4 Service Manual: Installation
- Install front bumper side retainer lh
- Install the clip and bumper side retainer.
- Install the bolt.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf)
- Install front bumper side retainer rh
Hint:
Use the same procedures described for the lh side.
- Install front bumper reinforcement
- Install the reinforcement with the 8 bolts.
Torque: 70 n*m (713 kgf*cm, 51 ft.*Lbf)
- Install the wire harness and attach the 5 claws.
- Install front bumper retainer
- Install the bolt with the retainer.
- Install no. 2 Front bumper energy absorber
- Install the absorber.
- Install front bumper cover
- Put protective tape under the front fender and
headlight.
- Install the 4 clips.
- Install the hood cushion center.
- W/ fog light:
connect the 2 fog light connectors.
- Attach the 4 claws to install the bumper cover.
- Install the 8 screws.
- Install radiator support opening cover
- Install the 2 clips.
- Install radiator grille protector
- Install the 2 radiator grille protectors.
- Install front fender liner lh
- Install the fender liner with the fender liner retainer.
- W/ splash shield:
install the front fender splash shield lh.
- Install the screw, nut and bolt.
- Install front fender liner rh
Hint:
Use the same procedures described for the lh side.
- Connect cable to negative battery
terminal
V
Attach the 7 outside moulding retainers to install the
extension.
Install front bumper extension rh (for wide
body)
Hint:
Use the same procedures described for the lh side ...
Components
Removal
Remove rear bumper cover
Remove the 9 screws and 7 clips.
Put protective tape under the quarter panel.
Detach the 12 claws and remove the bumper cover.
...
Other materials:
Inspection
Inspect starter assembly
Notice:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
Perform the pull-in test.
Disconnect the lead wire from terminal c.
Connect the battery to the magnetic switch as
shown in the illustration. Check that the clutch ...
Terminals of ecm
Hint:
The standard normal voltage between each pair of ecm
terminals is shown in the table below. The appropriate
conditions for checking each pair of terminals are also
indicated. The result of checks should be compared with the
standard normal voltage for that pair of terminals, displayed ...
Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler
using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and spoiler excessively.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
...