Toyota RAV4 Service Manual: Installation
Notice:
Do not heat the vehicle body, emblem and name plate excessively.
Hint:
When installing the emblem and name plate, heat the vehicle body, emblem and name plate using a heat light.
Standard heating temperature
- Install no. 4 Back door name plate (for 4wd)
- Clean the vehicle body surface.
- Using a heat light, heat the vehicle body surface.
- Remove the double-sided tape from the vehicle body.
- Wipe off any tape adhesive residue with cleaner.
- If reusing the name plate:
Clean the name plate.
- Using a heat light, heat the name plate.
- Remove the double-sided tape from the name plate.
- Wipe off any tape adhesive residue with cleaner.
- Apply new double-sided tape to the name plate.
- Install the name plate.
- Using a heat light, heat the vehicle body and name plate.
- Remove the peeling paper from the face of the name plate.
Hint:
After removing the peeling paper, keep the exposed adhesive free from foreign matter
- Install the name plate.
Notice:
Install the name plate exactly according to the specifications below.
Standard measurement
- Install no. 1 Back door emblem
- Install back door name plate
- Install no. 1 Back door emblem assembly
- Clean the vehicle body surface.
- Using a heat light, heat the vehicle body surface.
- Remove the double-sided tape from the vehicle body.
- Wipe off any tape adhesive residue with cleaner.
- If reusing the name plate and emblem: clean the name plate and emblem.
- Using a heat light, heat the name plate and emblem.
- Remove the double-sided tape from the name plate and emblem.
- Wipe off any tape adhesive residue with cleaner.
- Apply new double-sided tape to the name plate and emblem.
- Install the name plate and emblem.
- Using a heat light, heat the vehicle body, name plate and emblem.
- Remove the peeling paper from the face of the name plate and emblem.
Hint:
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
- Install the name plate and emblem.
Notice:
Install the name plate and emblem exactly according to the specifications below.
Standard measurement 
Removal
Notice:
Do not heat the vehicle body, emblem and name plate
excessively.
Hint:
When removing the emblem and name plate, heat the vehicle
body, emblem and name plate using a heat light.
Standard ...
Ebxotdeyrior rear spoiler
Components
...
Other materials:
Driver side seat belt warning light does not operate
Description
When the ignition switch is on, the center airbag sensor transmits front seat
inner belt status signals to
the combination meter through the can bus line. If the driver seat belt is not
fastened, the combination
meter blinks the driver side seat belt warning light. If the seat bel ...
Handling of hose clamps
Before removing the hose, check the clamp position
so that it can be reinstalled in the same position.
Replace any deformed or dented clamps with new
ones.
When reusing a hose, attach the clamp on the
clamp track portion of the hose.
For a spring type clamp, you may want to spread ...
Diagnostic trouble code chart
Look for output diagnostic trouble codes (dtcs) (from the
dtc checks) in the appropriate section's diagnostic trouble
code chart. Use the chart to determine the trouble area and
the proper inspection procedure. A description of each of the
chart's columns are below.
Item
Description
...
