Toyota RAV4 Service Manual: Installation
Hint:
- When installing the spoiler, heat the vehicle body and spoiler using a heat light.
Standard heating temperature 
Notice:
Do not heat the body and spoiler excessively.
- Install center stop light
- Install the center stop light with the 2 screws.
- Install rear spoiler
- Clean the vehicle body surface.
- Using a heat light, heat the vehicle body surface
- If reusing the spoiler:
Clean the spoiler.
- Using a heat light, heat the spoiler.
- Connect the center stop light connector.
- Install the spoiler with 3 clips.
- Install the 3 bolts.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*Lbf)
- Install back door center garnish (see page ed-67)
- Connect cable to negative battery terminal
Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler
using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and spoiler excessively.
Disconnect c ...
Roof rack
...
Other materials:
Transmission fluid temperature sensor "A" performance
Description
Refer to dtc p0710 (see page ax-46).
Monitor description
This dtc indicates that there is a problem with output from the atf
temperature sensor and that the
sensor itself is defective. The atf temperature sensor converts the atf
temperature to an electrical
resistance v ...
Vehicle speed sensor
Description
Refer to the sfi system (see page es-224).
Wiring diagram
Refer to the sfi system (see page es-224).
Inspection procedure
Refer to the sfi system (see page es-224). ...
Reassembly
Install wiring harness clamp bracket
Install the bracket with the bolt.
Install elbow tube
Install straight pin
Using a plastic hammer, install the 4 straight pins to
the rear differential carrier.
Thoroughly clean oil and water from the surface of
the rear different ...
