Toyota RAV4 Service Manual: Installation
- Replace roof carrier seal
- Remove the seals.
- Install new seals as shown in the illustration.
- Install roof rack leg front lh
- Install the leg cushion front.
- Install the roof rack leg front with the 2 screws.
Torque: 2.8 To 5.0 N*m (29 to 51 kgf*cm, 25 to 44 in.*Lbf)
- Install roof rack leg rear lh
- Install the leg cushion rear.
- Install the roof rack leg rear with the 2 screws.
Torque: 2.8 To 5.0 N*m (29 to 51 kgf*cm, 25 to 44 in.*Lbf)
- Install roof rack assembly lh
- Install the roof rack with the 4 bolts.
Torque: 38 n*m (387 kgf*cm, 28 ft.*Lbf)
- Install roof rack leg cover rear lh
- Install the leg cover.
- Attach the rib to the bar.
- Attach the 4 claws.
- Install roof rack leg cover front lh
- Install the leg cover.
- Attach the rib to the bar.
- Attach the 4 claws.
- Install roof rack bar front
- Install the roof rack bar with the 4 screws.
Torque: 1.96 To 2.94 N*m (20 to 30 kgf*cm, 17 to 26 in.*Lbf)
- Install roof rack support sub-assembly center
- Install the roof rack support center with the 4 roof carrier caps.
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove roof rack support sub-assembly center
Remove the 4 roof carrier ...
Front door belt moulding
Components
...
Other materials:
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the cruise control
system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
Che ...
Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler
using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and spoiler excessively.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
...
Terminals of ecu
Check instrument panel junction block (main body ecu)
Measure the voltage of the connectors.
If the result is not as specified, the junction block
(main body ecu) may have a malfunction. ...
