Toyota RAV4 Service Manual: Installation
Hint:
- Use the same procedures for the rh side and lh side.
- The procedures listed below are for the lh side.
- Install front door belt moulding assembly lh
- Attach the claws to install the belt moulding.
Hint:
Confirm that the moulding is firmly installed.
- Install outer rear view mirror assembly lh (see page mi-12)
- Install front door trim board subassembly lh (see page ed-33)
- Install front armrest base panel upper lh (see page ed-34)
- Install front door lower frame bracket garnish lh (see page ed-35)
- Connect cable to negative battery terminal
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery terminal
Notice:
Wait at least 90 sec ...
Rear door belt moulding
Components
...
Other materials:
Rear occupant classification sensor rh circuit malfunction
Description
The rear occupant classification sensor rh circuit consists of the occupant
classification ecu and the
rear occupant classification sensor rh.
Dtc b1783 is recorded when a malfunction is detected in the rear occupant
classification sensor rh
circuit.
Wiring diagram
...
System voltage
Description
The battery supplies electricity to the ecm even when the ignition switch is
in the off position. This
power allows the ecm to store data such as dtc history, freeze frame data and
fuel trim values. If the
battery voltage falls below a minimum level, the memory is cleared and ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
