Toyota RAV4 Service Manual: Installation
Hint:
- Use the same procedures for the rh side and lh side.
- The procedures listed below are for the lh side.
- When replacing the clip, heat the clip and body using a heat light.
Standard heating temperature 
Notice:
Do not heat the clip and vehicle body excessively.
- Replace roof drip side finish moulding clip
Hint:
Use the procedures below to replace damaged or accidentally removed clips. If this step is not necessary, go to the next step.
Notice:
After press-fitting the clips, wait 30 minutes or more before installing the moulding.
Hint:
- Minimum hardening time: 30 minutes
- Time needed for complete hardening: 24 hours
- Remove the double-sided tape that remains on the surfaces of the moulding and vehicle body, and then clean the surface with white gasoline.
- Using a heat light, heat the clip installation surface of the vehicle body and installation part of the clips.
- Install roof drip side finish moulding lh
- Install the no. 2 Center roof drip side finish moulding and roof drip side finish moulding.
- Install the 2 roof drip moulding joint covers to the vehicle body.
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove roof drip side finish moulding lh
Remove the 2 roof drip moulding j ...
Outside moulding
Components
...
Other materials:
Opening the back door from outside the vehicle
Back door opener
Vehicles without a power
back door
Raise the back door while
pressing up the back door
opener switch.
Vehicles with a power back
door
When the back door is
unlocked: press the back door
opener switch.
When the back door is locked
(vehicles with a smart key ...
Replacement
Replace generator drive end frame bearing
Remove the 4 screws and bearing retainer.
Using sst and a hammer, tap out the bearing.
Sst 09950-60010 (09951-00250), 09950-70010
(09951-07100)
Using sst and a press, press in a new bearing.
Sst 09950-60010 (09951-00250), 09 ...
How to proceed with troubleshooting (2005/11-2006/01)
Hint:
Use these procedures to troubleshoot the air conditioning
system.
*: Use the intelligent tester.
Vehicle brought to workshop
Customer problem analysis and symptom check
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, rechar ...
