Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

  1. Install fan and generator v belt

Toyota RAV4. Install fan and generator v belt


  1. Using sst and 19 mm socket wrench, loosen the vribbed belt tensioner arm clockwise, then install the fan and generator v belt.

Sst 09216-42010

Notice:

  1. Install front suspension member reinforcement rh

  1. Install the reinforcement rh with the 4 bolts.

    Torque: 96 n*m (979 kgf*cm, 71 ft.*Lbf)

  1. Install front fender apron rh

  2. Install front wheel rh

  3. Install radiator support opening cover

Removal
Remove radiator support opening cover Remove front wheel rh Remove front fender apron rh Remove front suspension member reinforcement rh Remove the 4 bolts and reinforcement rh. ...

Valve clearance
Adjustment Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat ...

Other materials:

Blower motor circuit
Description When the heater control (blower switch) is set to position 1 or higher, the contact of the htr relay is closed, current flows to the blower motor, and the blower motor operates. The blower motor speed can be changed by exchanging the ground and the blower resistor circuit with the ...

Precaution
Tire pressure warning system precaution When the tire pressure warning light turns on, immediately check the tire pressure of the tire and adjust it to the specified value. (When the tire pressure warning light circuit is open, the tire pressure warning light flashes for 1 minut ...

Removal
Discharge refrigerant from refrigeration system (see page ac-172) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove ...

В© 2011-2026 Copyright www.trav4.net