Toyota RAV4 Service Manual: Installation
- Install mass air flow meter
- Install the mass air flow meter with the 2 screws.
Notice:
Make sure that the o-ring is not cracked or jammed when installing it.
- Connect the mass air flow meter connector.
- Connect cable to battery negative terminal
Removal
Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensi ...
Camshaft timing oil control valve assembly
Components
...
Other materials:
Parking brake assembly
Components
Disassembly
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Remove rear wheel
Disconnect rear disc brake cylinder
mounting lh (see page br-55)
Remove parking brake shoe adjusting
hole plug
Remove t ...
Using the aux port
To use the aux port, connect a portable player, press the
“audio” button, then select “aux” to display the audio control
screen.
Connecting a portable audio player
Operating portable audio players connected to the audio system
The volume can be adjusted using the vehicle’s audio contr ...
Installation
Install engine coolant temperature
sensor
Install a new gasket onto the sensor.
Using sst, install the sensor.
Sst 09817-33190
torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf)
Connect the sensor connector.
Install air cleaner case (see page es-431)
Install air cleaner cap ( ...
