Toyota RAV4 Service Manual: Installation
- Install camshaft position sensor
Notice:
Make sure that the o-ring is not cracked or jammed when installing it.
- Apply a light coat of engine oil to the o-ring of the sensor.
- Install the sensor with the bolt.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf)
- Connect the sensor connector.
- Install air cleaner cap (see page es-413)
- Connect cable to negative battery terminal
- Check for engine oil leakage
- Install no. 1 Engine cover (see page es-414)
Inspection
Inspect camshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to 50 ...
Crankshaft position sensor
Components
...
Other materials:
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove accelerator pedal rod
Disconnect the accelerator pedal position ...
Blower unit
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove upper instrument panel
Remove the upper ...
Reassembly
Caution:
Wear protective gloves. Sharp areas on the seat frame
(with adjuster) may injure your hands.
Install front seat wire
Install seat position airbag sensor (see
page rs-390)
Install lumbar support adjuster assembly
Install the lumbar support adjuster with the 2
screws.
...
