Toyota RAV4 manuals

Toyota RAV4 Service Manual: Installation

  1. Install engine coolant temperature sensor

  1. Install a new gasket onto the sensor.
  2. Using sst, install the sensor.

Sst 09817-33190 torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf)

  1. Connect the sensor connector.

Toyota RAV4. Installation


  1. Install air cleaner case (see page es-431)

  2. Install air cleaner cap (see page es-413)

  3. Connect cable to negative battery terminal

  4. Add engine coolant (see page co-6)

  5. Check for coolant leakage (see page co-1)

Inspection
Inspect engine coolant temperature sensor Measure the resistance of the sensor. Standard resistance Notice: If checking the sensor in water, be careful not to allow water to contac ...

Throttle body
Components ...

Other materials:

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove front fender liner lh Remove front fender liner lh Remove the ...

Registration
Notice: The vehicle identification number (vin) must be input into the replacement ecm. Hint: The vin is a 17-digit alphanumeric number. The intelligent tester is required to register the vin. Description This registration section consists of 3 parts: input instructions, read vin and wr ...

Evaporative emission control system incorrect purge flow
Dtc summary Description The description can be found in the evap (evaporative emission) system (see page es-335). Inspection procedure Refer to the evap system (see page es-340). Monitor description The two monitors, key-off and purge flow, are used to detect malfunctions relating ...

В© 2011-2024 Copyright www.trav4.net