Toyota RAV4 Service Manual: Installation
- Install knock sensor
- Install the sensor with the nut.
Torque: 20 n*m (205 kgf*cm, 15 ft.*Lbf)
Notice:
Make sure that the knock sensor is in the
correct position.
- Connect the sensor connector.
- Install intake manifold insulator
- install the intake manifold insulator onto the cylinder
block.
- Install intake manifold
- Install a new gasket into the intake manifold.
- Install the intake manifold with the 5 bolts and 2
nuts.
Torque: 30 n*m (305 kgf*cm, 22 ft.*Lbf)
- Fit the union to check valve hose into the vacuum
hose clamp.
- Install the wire harness clamp.
- Connect the camshaft timing oil control valve
connector.
- Connect the union to check valve hose to the brake
booster.
- Connect heater water outlet hose
- Install the heater water outlet hose to the water bypass
pipe and heater radiator unit.
- Connect heater water inlet hose
- Install the heater water inlet hose to the cylinder
head and heater radiator unit.
- Install the hose clamp.
- Install fuel tube
- Install fuel delivery pipe (see page fu-13)
- Install throttle body (see page es-413)
- Install air cleaner cap (see page es-413)
- Connect cable to negative battery
terminal
- Add engine coolant (see page co-6)
- Check for engine coolant leakage (see
page co-1)
- Check for fuel leakage (see page fu-14)
- Install no. 1 Engine cover (see page es-414)
Inspect knock sensor
Measure the resistance of the sensor.
Standard resistance
If the result is not as specified, replace the knock
sensor. ...
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airb ...
Other materials:
Automatic transaxle fluid
On-vehicle inspection
Check transaxle fluid level
Hint:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°c (158 to 176°f)
Park the vehicle on a level surface and set the
parking brake.
With the engine idling and ...
Freeze frame data
Freeze frame data
Notice:
It is difficult to show the specified values
(judgment values) clearly because freeze frame
data values change significantly due to
differences in measurement conditions,
surroundings, or vehicle conditions. For this
reason, there may be a problem even w ...
Occupant classification ecu
Components
On-vehicle inspection
Inspect occupant classification ecu
(vehicle not involved in collision)
Perform a diagnostic system check (see page rs-
236).
Inspect occupant classification ecu
(vehicle involved in collision)
Perform a diagnostic system check (see p ...