Toyota RAV4 Service Manual: Installation
- Install ecm
- Install the 2 brackets to the ecm with the 4 screws.
Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf)
- Connect the 2 ecm connectors.
Notice:
When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.
- Connect the 2 ecm connectors and lower the 2 levers.
Notice:
Make sure that the 2 levers are securely lowered.
- Install the ecm with the 3 bolts.
Torque: 6.5 N*m (66 kgf*cm, 57 in.*Lbf)
- Install air cleaner case
- Install the air cleaner case with the 3 bolts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*Lbf)
- Connect the harness clamp.
- Install air cleaner cap (see page es-413)
- Connect cable to negative battery terminal
- Perform registration
- When replacing the ecm, the vehicle identification number (vin) must be input into the replacement ecm (see page es-13).
- When replacing the ecm, perform the vehicle stability control system recognition in the ecm (see page cc-12).
- Reset memory
- When replacing the ecm, perform the reset memory procedure (a/t initialization) (see page ax-18).
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt preten ...
Accelerator pedal rod
Components
...
Other materials:
Abs control system malfunction
Description
This dtc is output when the vsc system detects a malfunction in the abs
system.
Inspection procedure
Check dtc for abs system
Clear the dtc (see page bc-47).
Turn the ignition switch on.
Check if the same dtc is recorded (see page bc-47).
Result
Repair ...
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed for the dtc in the table below (refer to the appropriate
page).
Hint:
When the srs warning light remains on and the normal
system code is output, a decrease in the source voltage is
likely to occur. This malfunction is n ...
Idle control system malfunction
Description
The idling speed is controlled by the etcs (electronic throttle control
system). The etcs is comprised
of: 1) the one valve type throttle body; 2) the throttle actuator, which
operates the throttle valve; 3) the
throttle position (tp) sensor, which detects the opening angle of ...
