Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation
- Install accelerator pedal rod
- Install the accelerator pedal rod with the 2 bolts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*Lbf)
- Connect the accelerator pedal position sensor connector.
- Connect cable to negative battery terminal
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt preten ...
2Az-fe ignition
...
Other materials:
Listening to an ipod
Connecting an ipod enables you to enjoy music from the vehicle
speakers.
Select “ipod” on the audio source selection screen.
When the ipod connected to the system includes ipod video, the
system can only output the sound by selecting the browse
screen.
Connecting an ipod
Audio control ...
Short in front passenger side pretensioner squib circuit
Description
The front passenger side front pretensioner squib circuit consists of the
center airbag sensor and the front
seat outer belt rh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in th ...
Input signal circuit abnormal
Description
This dtc expresses the internal abnormalities of the ecm.
Inspection procedure
Check for dtc
Clear the dtc (see page cc-15).
Check for dtc (see page cc-15).
Ok:
dtc is not output.
End ...
