Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation
- Install starter assembly
- Install the starter with the 2 bolts.
Torque: 37 n*m (377 kgf*cm, 27 ft.*Lbf)
- Connect the starter connector.
- Install the terminal nut and cover the nut with the cap.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*Lbf)
- Install battery bracket reinforcement
- Install the bracket reinforcement.
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
- Install front battery bracket
- Install the bracket front with the 4 bolts.
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
- Attach the 2 wire harness clamps.
- Install battery
- Install battery insulator
- Install battery clamp
- Attach the hook of the battery clamp to the battery bracket front.
- Temporarily tighten the nut and install the bolt.
- Adjust the battery clamp's position.
- Fully tighten the nut and bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*Lbf)
- Attach the 2 wire harness clamps.
- Connect cable to positive battery terminal
- Connect cable to negative battery terminal
Reassembly
Hint:
Use high-temperature grease to lubricate the bearings,
gears, return spring and steel ball when assembling the
starter.
Install planetary gear
Apply grease to the planetary gears an ...
Starter relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airb ...
Other materials:
If the electronic key does
not operate properly
(vehicles with a
smart key system)
If communication between the electronic key and vehicle is
interrupted („_p. 107) Or the electronic key cannot be used
because the battery is depleted, the smart key system and wireless
remote control cannot be used. In such cases, the doors
can be opened and the engine can be started by follo ...
Road test
Problem symptom confirmation
Based on the result of the customer problem
analysis, try to reproduce the symptoms. If the
problem is that the transaxle does not shift up, shift
down, or the shift point is too high or too low,
conduct the following road test referring to the
automat ...
Low battery positive voltage
Description
When there is an abnormality in the power supply circuit of the brake
actuator (skid control ecu), the skid
control ecu sets a dtc and the operation is prohibited by the fail-safe
function. This dtc is set when the
voltage supplied to terminal ig1 is outside the dtc detection ...
