Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation
- Install ignition switch assembly
- Install the ignition switch with the 2 screws.
- Install the ignition key cylinder light connector.
- Install the ignition switch connector.
- Install steering column cover lower
- Attach the 4 claws to install the steering column lower cover.
- Connect cable to negative battery terminal
Inspection
Inspect ignition switch assembly
Measure the resistance of the switch.
Standard resistance
If the result is not as specified, replace the switch
assembly. ...
2Az-fe charging
...
Other materials:
Check mode procedure
Panel diagnosis (indicator check)
Turn the ignition switch to lock.
Turn the ignition switch on while simultaneously
pressing the a/c control auto switch and the rec/
frs switch.
Check that all indicators and the display area are
turned on and off 4 times in succession at 1 second ...
Gcwr, twr and unbraked twr
Confirm that the gross trailer weight, gross combination weight, gross
vehicle weight, gross axle weight and tongue weight are all within the
limits.
Gcwr*
2Wd models: 5985 lb. (2715 Kg)
Awd models: 6100 lb. (2765 Kg)
Twr*
1500 Lb. (680 Kg)
Unbraked twr*
1000 Lb. (450 Kg)
*: ...
Seat heaters
Turns on the front left seat
heater (high)
Turns on the front left seat
heater (low)
Turns on the front right seat
heater (high)
Turns on the front right seat
heater (low)
The indicator light comes on.
The seat heaters can be used when
Vehicles without a smart key system
T ...
