Toyota RAV4 Service Manual: Installation
- Install generator assembly
- Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
- Install the generator with the 2 bolts.
Torque: 21 n*m (215 kgf*cm, 16 ft.*Lbf) for bolt a 52 n*m (530 kgf*cm, 38 ft.*Lbf) for bolt b
- Install the wire harness clamp.
- Install the wire harness clamp bracket with the bolt.
Torque: 8.4 N*m (85 kgf*cm, 74 in.*Lbf)
- Connect the generator wire with the nut.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*Lbf)
- Install the terminal cap.
- Connect the generator connector.
- Install fan and generator v belt
- Install the belt (see page em-7).
- Connect cable to negative battery terminal
Reassembly
Install generator rotor assembly
Install the washer onto the generator rectifier end
frame.
Install the generator rotor onto the generator
rectifier end frame.
Usi ...
Battery current sensor
On-vehicle inspection
Check battery current sensor assembly
Measure the resistance of the sensor.
Standard resistance
If the result is not as specified, replace the sensor
assembly.
...
Other materials:
Vsc warning light remains on
Description
The skid control ecu is connected to the combination meter via the can
communication system.
W/o multi information display:
if the skid control ecu stores any dtcs which relate to the vsc system, the vsc
warning light comes on
in the combination meter.
W/ multi information d ...
Fastening the seat belt (for the rear center seat)
Press the plate to release, and
then pull the seat belt.
Push the plate into the buckle in
the order of plate “a” and plate
“b” until a clicking sound is
heard.
Plate “a”, buckle “a”
Plate “b”, buckle “b”
...
Second brake piston
Components
Disassembly
Remove 2nd brake piston return spring sub-assembly
Place sst on the return spring and compress.
Using a screwdriver, pry out the snap ring.
Remove the piston return spring.
Inspect 2nd brake piston return spring sub-assembly (see page ax-223)
...
