Toyota RAV4 Service Manual: Installation (2006/01- )
- Install sliding roof weatherstrip
- Install the sliding roof weatherstrip.
- Position the joint of the weatherstrip at the rear
center.
- Align the marks on the weatherstrip with the
middle marks at the corners of the plastic on
the edge of the sliding roof panel and install the
weatherstrip. Make sure that the marks on the
weatherstrip are positioned within the area
indicated by the marks at the corners of the
plastic on the edge of the sliding roof panel.
- Install the lip of the weatherstrip firmly.
- Install sliding roof housing assembly
- Install the housing with the 4 bolts and 8 nuts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*Lbf)
- Connect sliding roof drain hose
- Connect the 4 drain hoses.
Notice:
The clip must face toward the outside of the
vehicle and also be above the lower surface of
the sliding roof housing when installing the
drain hoses.
- Install sliding roof glass sub-assembly
- Using a t25 "torx" driver, temporarily install the
sliding roof glass sub-assembly with the 4 screws.
- Perform a level check.
- Check the difference in level for "a" between
the roof panel and the upper surface of the
weatherstrip when the sliding roof glass is fully
closed.
Standard measurement
Hint:
"+" Represents the condition that the glass is
above the panel level. "-" Represents the
condition that the glass is below the panel level.
- Perform a gap check.
- Check the gap between the roof panel and roof
glass.
Notice:
The gap must be even all around.
- Using a t25 "torx" driver, install the sliding roof
glass with the 4 screws.
Torque: 4.0 N*m (41 kgf*cm, 35 in.*Lbf)
- Install sliding roof side garnish lh
- Attach the claws to install the garnish.
- Install sliding roof side garnish rh
Hint:
Use the same procedures described for the lh side.
- Check for water leaks
- Adjust the sliding roof glass sub-assembly, and
check for water leaks.
- If there are any leaks, readjust the sliding roof glass
sub-assembly.
- Install roof headlining assembly
- Install the roof headlining (see page ir-59).
- Connect cable to negative battery terminal
Install sliding roof weatherstrip
Install the sliding roof weatherstrip.
Position the joint of the weatherstrip at the rear
center.
Align the marks on the weatherstrip with the
...
Removal
Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt ...
Other materials:
Rear occupant classification sensor lh collision detection
Description
Dtc b1787 is output when the occupant classification ecu receives a collision
detection signal sent by
the rear occupant classification sensor lh when an accident occurs.
Dtc b1787 is also output when the front seat assembly rh is subjected to a
strong impact, even if an
actua ...
Inspection
Inspect crankshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to 50°c (14 to
122°f) and hot is from 50 to 100°c (122 to
212°f).
If the result is not as specif ...
Precaution
Caution:
The vehicle is equipped with a supplemental restraint
system (srs), which consists of a steering pad, front
passenger airbag, curtain shield airbag, front seat side
airbag, seat belt pretensioner, center airbag sensor,
front airbag sensor, side airbag sensor, rear airbag
senso ...