Description
The intake air temperature (iat) sensor, mounted on the mass air flow (maf) meter, monitors the iat.
The iat sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the iat is low, the resistance of the thermistor increases. When the temperature is high, the resistance drops. These variations in resistance are transmitted to the ecm as voltage changes (see fig. 1).
The iat sensor is powered by a 5 v supply from the tha terminal of the ecm, via resistor r.
Resistor r and the iat sensor are connected in series. When the resistance value of the iat sensor changes, according to changes in the iat, the voltage at terminal tha also varies. Based on this signal, the ecm increases the fuel injection volume when the engine is cold to improve driveability.
Monitor description
The ecm performs obd ii monitoring based on the values from the intake air temperature sensor. If there is no change of the sensor value within the normal range, the ecm will not be able to perform obd ii monitoring or will misdiagnose that there is a malfunction in the sensor. The ecm detects the stuck intake air temperature sensor value by performing monitoring after the ignition switch is turned off or the engine is started (short soak or long soak).
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Wiring diagram
Refer to dtc p0110 (see page es-88).
Inspection procedure
Hint:
If any dtcs other than p0111 are output, troubleshoot those dtcs first.
Check for short circuit
If the wire harness is ground shorted (fig. 5), Locate
the section by conducting a resistance check with
the body ground (below).
Check the resistance with the body ground.
Disconnect connectors a and c, and measure
the resistance
Standard resistance (fig. 6)
Hint:
Measure ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Reassembly
Bearing position
Standard bearing position
Install differential gear lube apply tube
Install the apply tube and clamp to the transaxle
housing with the bolt.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*Lbf)
Notice:
Make sure to insert the pipe to the stopper.
Instal ...