Toyota RAV4 (XA40) 2013-2018 Service Manual: Lighting
- Lighting system
- Parts location
- System description
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu
- Data list / active test
- Headlight assembly
- Fog light assembly
- Rear combination light assembly
- License plate light assembly
- High mounted stop light assembly
- Map light assembly
- Room light assembly
- Luggage room light
- Ignition key cylinder light
- Vanity light
- Front console illumination
- Footwell light
- Headlight dimmer switch
- Hazard warning switch
- Front door courtesy switch
- Rear door courtesy switch
- Headlight relay
- Daytime running light relay
- Fog light relay
- Brk relay
Air conditioning control assembly (for manual air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Notice:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent air ...
Lighting system
...
Other materials:
Installation
Install accelerator pedal rod
Install the accelerator pedal rod with the 2 bolts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*Lbf)
Connect the accelerator pedal position sensor
connector.
Connect cable to negative battery terminal
...
Vehicle load limits
Vehicle load limits include
total load capacity, seating
capacity, TWR (Trailer
Weight Rating) and cargo
capacity.
Total load capacity (vehicle
capacity weight):
Total load capacity means the
combined weight of occupants,
cargo and luggage.
Seating capacity:
Seating capacity means the
max ...
Check mode procedure
Check mode (signal check)
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on.
Select the "signal check", and continue
checking with the intelligent tester.
Notice:
Select the "signal check" from the "dtc
check&quo ...
