Toyota RAV4 Service Manual: Luggage room light

Components

Removal

1. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. Remove back door center garnish (see page ed-59)

3. Remove back door side garnish lh (see page ed-59)

4. Remove back door side garnish rh (see page ed-59)

5. Remove back door trim board (see page ed- 59)

6. Remove back door courtesy light assembly

1. Using a screwdriver, pry out the light as shown in the illustration.

Hint:

Tape the screwdriver tip before use.

2. detach the 4 claws and remove the light shade.

3. Remove the light bulb from the light.

Installation

1. Install back door courtesy light assembly

1. Install the bulb to the light.

2. Attach the 4 claws to install the light shade.
3. Install the light as shown in the illustration.

2. Install back door trim board (see page ed- 66)

2. Install back door side garnish rh (see page ed-67)

3. Install back door side garnish lh (see page ed-67)

4. Install back door center garnish (see page ed-67)

5. Connect cable to negative battery terminal