Toyota RAV4 manuals

Toyota RAV4 Owners Manual: Maintenance requirements

To ensure safe and economical driving, day-to-day care and regular maintenance are essential. It is the owner’s responsibility to perform regular checks. Toyota recommends the following maintenance:

General maintenance

General maintenance should be performed on a daily basis. This can be done by yourself or by a toyota dealer.

Scheduled maintenance

Scheduled maintenance should be performed at specified intervals according to the maintenance schedule.

For details about maintenance items and schedules, refer to the “scheduled maintenance guide” or “owner’s manual supplement”.

Do-it-yourself maintenance

You can perform some maintenance procedures by yourself.

Please be aware that do-it-yourself maintenance may affect warranty coverage.

The use of toyota repair manuals is recommended.

For details about warranty coverage, see the separate “owner’s warranty information booklet” or “owner’s manual supplement”.

Repair and replacement

It is recommended that genuine toyota parts be used for repairs to ensure performance of each system. If non-toyota parts are used in replacement or if a repair shop other than a toyota dealer performs repairs, confirm the warranty coverage.

Reset the maintenance data (u.S.A. Only)

After the required maintenance is performed according to the maintenance schedule, please reset the maintenance data.

To reset the data, follow the procedure described below:

Vehicles without a smart key system

  1. Switch the display to the trip meter a And then turn the engine switch to the lock¸ position.
  2. While pressing the disp¸ button , Turn the engine switch to the ¢§on¢¸ position (do not start the engine because reset mode will be canceled).
  3. Continue to press and hold the button until the trip meter displays “000000”.

Vehicles with a smart key system

  1. Switch the display to the trip meter a („_p. 88) And then turn the engine switch off.
  2. While pressing the ¢§disp¢¸ button („_p. 88), Turn the engine switch to ignition on mode (do not start the engine because reset mode will be canceled).
  3. Continue to press and hold the button until the trip meter displays “000000”.

Allow inspection and repairs to be performed by a toyota dealer

Caution

If your vehicle is not properly maintained

Improper maintenance could result in serious damage to the vehicle and possible death or serious injury.

Handling of the battery

Maintenance
...

General maintenance
Listed below are the general maintenance items that should be performed at the intervals specified in the “owner’s warranty information booklet” or “owner’s manual supplement/scheduled ma ...

Other materials:

Tire and wheel system
Inspection Inspect tire Check the tires for wear and proper inflation pressure. Standard cold tire inflation pressure: 220 kpa (2.2 Kgf/cm2, 32 psi) Using a dial indicator, check the runout of the tires. Standard tire runout: 1.0 Mm (0.039 In.) Or less Rotate tire ...

Shift solenoid "d" performance (shift solenoid valve s4)
System description The ecm uses signals from the output shaft speed sensor and input speed sensor to detect the actual gear position (1st, 2nd, 3rd or o/d gear). Then the ecm compares the actual gear with the shift schedule in the ecm memory to detect mechanical problems of the shift s ...

Replacement
Replace generator drive end frame bearing Remove the 4 screws and bearing retainer. Using sst and a hammer, tap out the bearing. Sst 09950-60010 (09951-00250), 09950-70010 (09951-07100) Using sst and a press, press in a new bearing. Sst 09950-60010 (09951-00250), 09 ...

© 2011-2024 Copyright www.trav4.net