Components
Removal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Hint:
Tape the screwdriver tip before use.
Disassembly
Inspection
Ok: light comes on.
If the result is not as specified, replace the light assembly.
Ok: light comes on.
If the result is not as specified, replace the light assembly.
Reassembly
Installation
Engine (ignition) switch
(vehicles with a
smart key system)
Performing the following operations when carrying the electronic
key on your person starts the engine or changes engine
switch modes.
Starting the engine
Check that the parking brake is set.
Check that the shift lever is set in p.
Firmly depress the brake pedal.
The smart key system in ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install front pillar cover sub-assembly upper lh
Attach the 3 clips to install the pillar cover.
...
Removal
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent air ...