Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Mass air flow meter

Components


Mil circuit
Description The mil (malfunction indicator lamp) is used to indicate vehicle malfunction detections by the ecm. When the ignition switch is turned on, power is supplied to the mil circuit, and ...

On-vehicle inspection
Notice: Perform the maf meter inspection according to the procedures below. Only replace the maf meter when both the long ft#1 value and maf value in the data list (with the engine stopped ...

Other materials:

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine. Allow the engine to idle for 10 minute ...

Only back door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Inspect back door with motor lock assembly Apply the battery voltage to the door lock motor and check the operation of the d ...

Footwell light
On-vehicle inspection Inspect footwell light Connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, then check that the light comes on. Ok: light comes on. If the result is not as specified, replace the light. ...

В© 2011-2026 Copyright www.trav4.net