Description
The master cylinder pressure sensor is connected to the skid control ecu in the abs and traction actuator.
Dtc c1281/81 can be detected when the master cylinder pressure sensor sends a master cylinder pressure signal or test mode ends. Dtc c1281/81 is output only in test mode.
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform zero point calibration (see page bc-24).
Ok: on (brake pedal is depressed) appears on the screen.
Ok: when the pedal is depressed, the sensor output voltage increases.
Result
Replace abs and traction actuator assembly
Wiper switch
Precaution
Precaution for vehicle with srs
Some procedures in this section may affect the
supplemental restraint system (srs). Prior to
performing the procedures, read the srs section's
"precaution" (see page ss-2).
Components
Removal
Disconnect cable from negat ...
Abbreviations used in manual
...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
actuator and other item values to be read without
removing any parts. Reading the data list early in
troubleshooting is one way to save time.
Connect the intelligent tester (with can vim) to the
dlc3.
Turn ...