Toyota RAV4 (XA40) 2013-2018 Service Manual: Multiplex communication circuit
Description
The air conditioning amplifier communicates data with the ecm and combination meter through the can communication system.
Wiring diagram
Inspection procedure
- Check dtc
- Clear the dtc (see page ac-127).
- Read the dtc (see page ac-127).
Result 
Go to can communication system
Compressor solenoid circuit (2006/01- )
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
ref ...
Blower motor circuit
Description
When the heater control (blower switch) is set to position 1 or higher, the
contact of the htr relay is
closed, current flows to the blower motor, and the blower motor operates. The
...
Other materials:
Front shock absorber with coil spring
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove front wheel
Disconnect front speed sensor lh
Disconnect front stabilizer link assembly
lh
Remove front shock absorber with coil spring lh
...
Wireless remote control
Function summary
The wireless remote control can be used to lock and unlock the vehicle.
It also opens and closes the back door.
Vehicles without a smart key system
Locks all the doors
Unlocks all the doors
Pressing the button unlocks the
driver’s door. Pressing the button
again wi ...
Transmission range sensor circuit malfunction (prndl input)
Description
The park/neutral position (pnp) switch detects the shift lever position and
sends signals to the ecm.
Monitor description
These dtcs indicate a problem with the park/neutral position switch and the
wire harness in the park/
neutral position switch circuit.
The park/neu ...
